国产精品久久久久无码av色戒,大帝av在线一区二区三区,国产肥熟女视频一区二区三区,大陆少妇xxxx做受,被黑人猛躁10次高潮视频

1FEATURES

2? Qualified for Automotive Applications

? Two-, Three-, or Four-Phase Operation

? 5-V to 15-V Operating Range

? Programmable Switching Frequency Up to

1-MHz/Phase

? Current Mode Control With Forced Current

Sharing (1)

? 1% Internal 0.7-V Reference

? Resistive Divider Set Output Voltage

? True Remote Sensing Differential Amplifier

? Resistive or DCR Current Sensing

? Current Sense Fault Protection

? Programmable Load Line

? Compatible with UCC37222 Predictive Gate

Drive? Technology Drivers

? 24-Pin Space-Saving TSSOP Package

? Binary Outputs

(1) Patent pending

APPLICATIONS

? Internet Servers

? Network Equipment

? Telecommunications Equipment

? DC Power Distributed Systems

DESCRIPTION

The TPS40090 is a two-, three-, or four-phase programmable synchronous buck controller that is optimized for

low-voltage, high-current applications powered by a 5-V to 15-V distributed supply. A multi-phase converter offers

several advantages over a single power stage including lower current ripple on the input and output capacitors,

faster transient response to load steps, improved power handling capabilities, and higher system efficiency.

Each phase can be operated at a switching frequency up to 1-MHz, resulting in an effective ripple frequency of

up to 4-MHz at the input and the output in a four-phase application. A two-phase design operates 180° out of

phase, a three-phase design operates 120° out of phase, and a four-phase design operates 90° out of phase, as

shown in Figure 1.

The number of phases is programmed by connecting the deactivated phase PWM output to the output of the

internal 5-V LDO. In two-phase operation the even phase outputs should be deactivated.

The TPS40090 uses fixed frequency, peak current mode control with forced phase current balancing. When

compared to voltage mode control, current mode results in a simplified feedback network and reduced input line

sensitivity. Phase current is sensed by using either current sense resistors installed in series with output

inductors or, for improved efficiency, by using the DCR (direct current resistance) of the filter inductors. The latter

method involves generation of a current proportional signal with an R-C circuit (shown in Figure 11).

The R-C values are selected by matching the time constants of the R-C circuit and the inductor; R-C = L/DCR.

With either current sense method, the current signal is amplified and superimposed on the amplified voltage error

signal to provide current mode PWM control.