国产精品久久久久无码av色戒,大帝av在线一区二区三区,国产肥熟女视频一区二区三区,大陆少妇xxxx做受,被黑人猛躁10次高潮视频

1 Features

1? Integrated Current Limiter

– Input Voltage Range: 1.62 V to 4.5 V

– Low ON-Resistance

– rON = 300-mΩ at VIN = 4.5 V

– r ON = 350-mΩ at VIN = 3.3 V

– rON = 400-mΩ at VIN = 2.5 V

– r ON = 600-mΩ at VIN = 1.8 V

– Integrated 100-mA Minimum Current Limit

– Undervoltage Lockout

– Fast-Current Limit Response Time

– Integrated Fault Blanking and Auto Restart

? Stable Without Current Limiter Output Capacitor

(TPS22949A Only)

? Integrated Low-Noise RF LDO

– Input Voltage Range: 1.62 V to 4.5 V

– Low Noise: 50 μVrms (10 Hz to 100 kHz)

– 80-dB VIN PSRR (10 Hz to 10 kHz)

– Fast Start-Up Time: 130 μs

– Low Dropout 100 mV at I load =100 mA

– Integrated Output Discharge

– Stable With 2.2-μF Output Capacitor

? 1.8-V Compatible Control Input Threshold

? ESD Performance Tested Per JESD 22

– 3500 V Human Body Model

(A114-B, Class II)

– 1000 V Charged Device Model

(C101)

? Tiny 8-Terminal YZP Package (1.9 mm × 0.9 mm,

0.5-mm Pitch, 0.5-mm Height) and WSON-8

(DRG) 3.0 mm × 3.0 mm

2 Applications

? Fingerprint Module Protection

? Portable Consumer Electronics

? Smart Phones

? Notebooks

? Control Access Systems

3 Description

The TPS22949 and TPS22949A are devices that

provide protection to systems and loads in high- current conditions. The device contains a 500-mΩ

current-limited P-channel MOSFET that can operate

over an input voltage range of 1.62 V to 4.5 V as well

as a low-dropout (LDO) regulator with a fixed output

voltage of 1.8 V.

The switch is controlled by an on/off input (EN1),

which can interface directly with low-voltage control

signals. When the switch current reaches the

maximum limit, the TPS22949/TPS22949A operates

in a constant-current mode to prohibit excessive currents from causing damage. If the constant current

condition persists after 12 ms, these devices shut off

the switch and pull the fault signal pin (OC) low. The

TPS22949/TPS22949A has an auto-restart feature

that turns the switch on again after 70 ms if the EN1 pin is still active.

The output of the current limiter is internally connected to an RF low-dropout (LDO) regulator that

offers good AC performance with very low ground

current, good power supply rejection ratio (PSRR),

low noise, fast start-up, and excellent line and load

transient response. The output of the regulator is

stable with ceramic capacitors. This LDO uses a

precision voltage reference and feedback loop to

achieve overall accuracy of 2% over all load, line, process, and temperature variations.