国产精品久久久久无码av色戒,大帝av在线一区二区三区,国产肥熟女视频一区二区三区,大陆少妇xxxx做受,被黑人猛躁10次高潮视频

FEATURES

· Operate From 1.65 V to 3.6 V

· Inputs Accept Voltages to 5.5 V

· Max tpd of 7.4 ns at 3.3 V

· Typical V OLP (Output Ground Bounce)

<0.8 at VCC = 3.3 V, TA = 25°C

· Typical V OHV (Output VOH Undershoot)

>2 V at VCC = 3.3 V, TA = 25°C

· Support Mixed-Mode Signal Operation on All

Ports (5-V Input/Output Voltage With

3.3-V VCC)

· Ioff Supports Partial-Power-Down Mode

Operation

· Latch-Up Performance Exceeds 250 mA Per

JESD 17

· ESD Protection Exceeds JESD 22

– 2000-V Human-Body Model (A114-A)

– 200-V Machine Model (A115-A)

– 1000-V Charged-Device Model (C101)

DESCRIPTION/ORDERING INFORMATION

The SN54LVC646A octal bus transceiver and register is designed for 2.7-V to 3.6-V VCC operation, and the

SN74LVC646A octal bus transceiver and register is designed for 1.65-V to 3.6-V VCC operation.

These devices consist of bus-transceiver circuits, D-type flip-flops, and control circuitry arranged for multiplexed

transmission of data directly from the input bus or from the internal registers. Data on the A or B bus is clocked

into the registers on the low-to-high transition of the appropriate clock (CLKAB or CLKBA) input. Figure 1

illustrates the four fundamental bus-management functions that are performed with the 'LVC646A devices.

Output-enable (OE) and direction-control (DIR) inputs control the transceiver functions. In the transceiver mode,

data present at the high-impedance port is stored in either register or in both.

The select-control (SAB and SBA) inputs can multiplex stored and real-time (transparent mode) data. DIR

determines which bus receives data when OE is low. In the isolation mode (OE high), A data is stored in one

register and B data can be stored in the other register.

When an output function is disabled, the input function still is enabled and can be used to store and transmit

data. Only one of the two buses, A or B, can be driven at a time.

Inputs can be driven from either 3.3-V or 5-V devices. This feature allows the use of these devices as translators

in a mixed 3.3-V/5-V system environment.

These devices are fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the

outputs, preventing damaging current backflow through the device when it is powered down.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.